Our recently released PA_CF Low Warp is a great material for making printed modifications for 3D printers. We printed the Rear Mount Feeder Bracket for the Ultimaker 2 with our new filament:

The design was made by Christopher Bray and can be downloaded here.

We printed this part on the Ultimaker 2+ with a 0.8mm Olsson Ruby nozzle 0.2mm layerheight and 260C nozzle temp. Of course this is not the only part that can be printed with our new functional filament: Fan mounts, motor mounts, extruder carriage, gears, etc. are all possibilities.

PA-CF Low Warp was released in the week before Christmas. It is our first foray into nylon based materials. The formulation has been modified to reduce the uptake of moisture by half compared to PA6 and it also takes about 4 times longer to reach the saturation point. This makes PA-CF Low Warp less sensitive to moisture then most other nylon filaments available in the market.

You can find more information about the printability of PA-CF Low Warp on our dedicated landing page.

The PA-CF Low Warp is a one of a kind polyamide formulation with the ability to print nearly warp free on non heated buildplatforms. Low infill prints come out perfectly flat on cold bed for higher infill prints 40/50C temperature is enough to obtain flat prints. This tailormade formulation of polyamide features the mechanical properties of a PA6. Tensile strength was measured at 77,99 MPa and impact strength (notched) was measured at 5,44KJ/m2, test specimens both printed on Ultimaker 2+, 260C 0.1mm layerheight with 100% infill.

PA-CF Low Warp is available now in our webshop and ships from stock.

The Olsson Ruby Nozzle – One nozzle for all materials

Due to the abrassive nature of the filament we recommend the use of hardened nozzles for the best performance of the material and printer. For this reason we are offering the Olsson Ruby Nozzles with the purchase of PA-CF Low Warp. You can find the combined offer here.

We have published about the use of the Olsson Ruby Nozzle before and we are very enthusiastic about the use of this filament combined with abrassive materials like PA-CF Low Warp, but also XT-CF20 and steelFill.

The ruby mounted at the tip assures that even the toughest materials will be printable. It was originally designed for printing with a composite of Boron Carbide (B4C), the third hardest known material in the world. Since most of the Olsson Ruby is made from brass, with its excellent heat conductivity, performance and throughput is first-class.

This nozzle, soon on your printer!

The Olsson Ruby is manufactured, assembled and tested in a high-quality facility in Sweden. This is why 3DVerkstan – also colorFabb’s partner in the region – guarantees the very best quality and tolerances.

As from now you can purchase the Olsson Ruby Nozzle 0.4mm in combination with PA-CF Low Warp in our webshop.

Recommended Posts

No comment yet, add your voice below!


Add a Comment

Your email address will not be published. Required fields are marked *